The Four-Ten $1795.00  Price includes: 40 watts of pure thunderous tone

• Two preamp tubes for gain/tone substitutions
• Spare rectifier and fuse
• Patch cable to bridge channels or use pedal
• Line out to PA feature
• Detailed color illustrated manual
• One-on-one customer service
• Chicago tone friendly initial setup
• Many variations possible
• Cashier's check or money order. PayPal accepted plus 3% fee

The Cruncher $1595.00  Price includes: 35 watts of LW/BW combined nasty tone

• Two preamp tubes for gain/tone substitutions
• Spare rectifier and fuse
• Patch cable to bridge channels or use pedal
• Line out to PA feature
• Detailed color illustrated manual
• One-on-one customer service
• Chicago tone friendly initial setup
• Many variations possible
• Cashier's check or money order. PayPal accepted plus 3% fee

Danelectro Dan-Echo Delay Pedal $90 (pedal) $20 (AC wall adapter)

I often hear the question "but what if I want a bit of reverb or delay with the amplifier... just for a taste to give it that wetness, slap-back sound when you hit a note?" I have tried many products and offer the Dan-Echo as my choice, priced at $90. The AC wall adapter is $20.

Custom Mics $295

I try to keep a stock of vintage 1950's Controlled Magnetic or Controlled Reluctance elements, the best of the best. These are loaded into a custom Turner shell that has a volume control on the back and female input in the belly. Ready to go, plug in and play. These have about a half inch smaller face than a green bullet or JT30, great for cupping and tight seal. I only sell these rare mics to my amp customers, these are the exact ones I personally use. The new Green Bullet DX or Bluesblaster can't even come close to comparing with the overall tone and output of these super tone friendly mics.

Matched Groove Tube 6L6 Power Tubes

Each pair of GE Style 6L6 are matched and graded by their degree of aggressiveness on a scale of 1 - 10. I use a wide variety of grade numbers to dial in each amplifier. When you need to replace your power tubes, if you use the same grade that is in there at the time, the bias should be extremely close to what it was when shipped, approximately 28 milliamps. If you have the option to test them after changing, it is always good to be exact, the bias pot allows you to dial the amp back in. I do offer Groove Tubes at a discount to my customers if needed.

Sonny Jr. amplifiers carry a non-transferrable warranty to the original owner as follows: Two years - chassis parts (transformers, resistors, capacitors); Three months - power tubes, rectifier, preamp tubes; Six months: speakers.  You mst contact Sonny first before any repair or work is done on an amplifier. Repairs and/or modifications made by anyone other than a Sonny Jr. approved technician voids the warranty. Parts and labor are covered with the following exceptions: misuse, abuse, and normal wear and tear. Shipping to and from a Sonny Jr. technician is the responsibility of the owner. In the event of a damaged speaker, the old one must be returned to us to be exchanged for a replacement.